Kenwood NEXEDGE NX-200 Function Reference page 200

8 NXDN CONVENTIONAL SYSTEM
8.10 Sending and Receiving a Short Message (Short Data Call)
 Sending a Short Message using a PC command
1
Send the PC command to the transceiver from a PC to request transmission of a Short Message.
The transceiver starts sending the Short Message.
If the Short Message is properly sent to the receiving transceiver,
"COMPLETE" appears.
Receiving a Short Message
Upon receiving a Short Message, the received Short Message appears on the main display, and the transceiver can send
the Short Message to an external device from the communication ports.
Item
The received Short Message appears on the transceiver main display.
If "Fixed" is configured for Message Display Type, only Short Message appears.
Display
The received Short Message appears on the main display for 3 sec and ID Name appears for 2 sec
alternately if "Alternate" is configured for Message Display Type.
Alert Tone Alert Tone sounds upon receipt of a Short Message.
The transceiver sends the received Short Message using a serial command. This message is sent to an
PC Command external device that is connected to the transceiver, such as a PC. (Refer to
Message from the Communication Port (Short Message Serial Output) on page
Note
• To use serial communications, a user must prepare NXDN compatible software or external devices.
• A maximum of 15 received Short Messages along with Status Messages can be stored in the stack memory of the transceiver.
(Refer to 3.7 Viewing the Receive History (Stack) on page
FUNC (K)/Ver 4.00
Table 8-17 Receiving a Short Message
Description
38.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
Sending the Received Short
168.)
CONTENTS INDEX 166