Kenwood NEXEDGE NX-200 Function Reference page 265

9 NXDN TRUNKING SYSTEM
9.10 Common Functions for Data Communications
Maximum ACK Wait Time
Maximum ACK Wait Time is the length of time that the transceiver stands by to receive the acknowledgment after the
transceiver sends data. If the transceiver does not receive the acknowledgment within the time configured for Maximum
ACK Wait Time, the transceiver resends data.
The default configuration is normally used.
Note
A Long Data Message transmits data divided over multiple times. The receiving transceiver stands by to receive the next data for the
time configured for Maximum ACK Wait Time after receiving the previous data. The transceiver exits Long Data Message Receive
Mode if the transceiver does not receive any data during the period.
Configuration using KPG-111D/ DN
Configuring the Maximum ACK Wait Time (
Received Message Display Type (Message Display Type)
Message Display Type can be used to display a message on the main display when the transceiver receives a Status
Message or Short Message.
Configuration
"STM/SDM" appears on the main display when the transceiver receives a Status Message or Short Message. A
Fixed
message is scrolled on the main display if the message is longer than 15 characters.
"STM/SDM" appears for 3 sec and Unit ID appears for 2 sec on the main display alternately upon receipt of a Status
Alternate
Message or Short Message.
Note
• The previous display appears again by pressing a key while the received message is displayed.
• This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Message Display Type (
FUNC (K)/Ver 4.00
See FPRG 8.19.2 General 1 Tab)
Table 9-8 Message Display Type
Description
See FPRG 8.19.2 General 1 Tab)
CONTENTS INDEX 231