Kenwood NEXEDGE NX-200 Function Reference page 492

19 SCAN
19.8 Common Functions for Scan
Scan Stop Tone
Scan Stop Tone is a function to emit a Scan Stop Tone from the transceiver while the scan pauses, for example, while the
transceiver is on a Home Channel or GID or Direct Channel or GID.
The transceiver pauses scanning if the conditions to start the scan are not satisfied, for instance while the transceiver is on
a Home Channel or GID, or Direct Channel or GID, and then the Scan Stop Tone sounds at 30-sec intervals.
Also, whether to emit the Scan Stop Tone can be configured using KPG-111D/ DN.
Configuration using KPG-111D/ DN
Configuring the Scan Stop Tone to be enabled or disabled (
Preamble Length (NXDN Conventional System only)
Preamble Length is the function to extend time for sending a preamble when the NXDN frame is sent.
Extending the time for sending a preamble at the beginning of transmission makes the receiving transceiver easier to
receive a call and reduces missing of the beginning of the audio during the scan.
The extended time of a preamble is determined by using the following equation.
Very Narrow:
Time [s] = 1/2400 x 4 x Configuration value for Preamble Length
Narrow:
Time [s] = 1/4800 x 8 x Configuration value for Preamble Length
Configuration using KPG-111D/ DN
Configuring the Preamble Length (
FUNC (K)/Ver 4.00
See
FPRG 8.19.5 Conventional Tab)
See
FPRG 8.13.1 Scan Tab)
CONTENTS INDEX 458