Kenwood NEXEDGE NX-200 Function Reference page 557

APPENDIX
Available Functions for the Selector (Portable Only)
Available Functions for the Selector (Portable Only)
The following functions can be assigned to the Selector using KPG-111D/ DN. What function can be selected will vary
depending on the configuration for 16 Zone/Channel Selector.
 If 16 Zone/Channel Selector is enabled (or for NX-200S/ NX-300S):
Function Name
No function is activated. Rotating the Selector causes the Key-entry Error Tone to
None
sound.
Rotating the Selector causes the transceiver to migrate to the channel or GID
CH/GID Select
indicated by the pointer of the Selector.
Rotating the Selector causes the transceiver to migrate to the zone indicated by
Zone Select
the pointer of the Selector.
Turning the Selector causes the transceiver to migrate to the site specified by the
Site Select Selector. (Refer to
page 236.)
*1
ALL indicates a function that can be used in all systems.
 If 16 Zone/Channel Selector is disabled (or for NX-210/ NX-410/ NX-411):
Function Name
No function is activated. Rotating the Selector causes the Key-entry Error Tone to
None
sound.
Rotating the Selector causes the channel or GID number to be increased or
CH/GID Up/Down
decreased in steps of 1.
Rotating the Selector causes the zone number to be increased or decreased in
Zone Up/Down
steps of 1.
Turning the Selector increases or decreases the site number in steps of 1. (Refer
Site Up/Down
to 9.16 Locking the Site to Be Used (Site Lock/ Site Select) on page
*1
ALL indicates a function that can be used in all systems.
Note
• Refer to CSI "2.6 Removing the Stopper from the Selector" for instructions on how to remove the stopper for the Selector.
• For NX-210/ NX-410/ NX-411, 16 Zone/Channel Selector is always configured to be disabled.
• For NX-200S/ NX-300S, 16 Zone/Channel Selector is always configured to be enabled.
Configuration using KPG-111D/ DN
• Assigning functions to the Selector on the transceiver (
• Configuring the 16 Zone/Channel Selector to be enabled or disabled (
FUNC (K)/Ver 4.00
Table 1-3 Available Functions for the Selector
Description
9.16 Locking the Site to Be Used (Site Lock/ Site Select) on
Table 1-4 Available Functions for the Selector
Description
See
236.)
FPRG 8.12.3 Top/Side Tab)
FPRG 8.12.2 General Tab)
See
CONTENTS
*1
Available System
ALL
ALL
ALL
NXDN Trunking System
*1
Available System
ALL
ALL
ALL
NXDN Trunking System
INDEX 523