Kenwood NEXEDGE NX-200 Function Reference page 481

19 SCAN
19.7 Transceiver Behavior during the Scan
 If "Multi" or "List" is configured for the Scan Type:
• The zones in an NXDN Trunking system (if the scan starts from zones in an NXDN Trunking system)
• The zones in a Conventional Group or an LTR Trunking system (if the scan starts from zones other than the
zones in an NXDN Trunking system)
Pressing the Scan Delete/Add key while scan pauses deletes or adds the current channel temporarily. This state is
retained until stopping the scan by pressing the Scan key or by selecting "Scan" in Menu Mode after pressing the Menu
key. A Priority Channel is always scanned regardless of the Delete/Add display.
Transceiver Behavior in the Case that the Scan Cannot Be Resumed
During the scan, the selected channel or GID appears and the "
a zone that does not meet the requirements to resume scanning. In this case, the scan does not resume.
The transceiver transmits using the Revert Channel or GID when the PTT switch is pressed while the "
Upon elapse of the time configured for Dwell Time after completion of the transmission, the transceiver reverts to the
selected channel or GID; however, the scan does not resume.
Transceiver Behavior in the Case That a Zone Channel (or GID) Is Changed during
the Scan
The transceiver scans as follows when the zone channel (or GID) is changed while the following appears on the main
display.
Table 19-2 Transceiver Behavior after the Zone Channel (or GID) Is Changed
Display
The transceiver pauses scanning on the selected channel or GID. The transceiver resumes scanning after the Key
SCAN
Delay Time elapses (1 sec).
The transceiver pauses scanning on the selected channel or GID if the Revert Channel or GID is different from the
Revert CH/GID
selected channel or GID.
 If the Home CH/GID key is pressed during the scan, the transceiver pauses scanning while the transceiver
is migrating to the Home Channel or GID and a Scan Stop Tone will continue to sound at 30-sec intervals.
(Refer to Scan Stop Tone on page
 If one of the Direct CH/GID 1 to Direct CH/GID 5 keys is pressed during the scan, the transceiver pauses
scanning while the transceiver is migrating to the Direct Channel or GID and also Scan Stop Tone will
continue to sound at 30-sec intervals. (Refer to
Transceiver Behavior in the Case That a Zone Channel (or GID) Is Changed Manually
while the Scan Pauses to Receive
The transceiver scans as below when a user manually changes the Zone-channel or GID while the scan pauses to
receive.
 The transceiver continues to pause scanning on the selected channel or GID if the channel or GID where
the transceiver pauses scanning differs from the selected channel or GID.
FUNC (K)/Ver 4.00
" icon blinks when the channel is changed manually to
Description
458.)
Scan Stop Tone on page
" icon is blinking.
458.)
CONTENTS INDEX 447