Kenwood NEXEDGE NX-200 Function Reference page 241

9 NXDN TRUNKING SYSTEM
9.5 Making an Individual Call (Transmission Trunked)
 Using the keypad
A Unit ID can be entered by pressing the [0] to [9] keys.
4
Press the PTT switch to initiate a Voice Call.
In order to initiate a Paging Call, the Side 2 key (NX-200/
NX-210/ NX-300/ NX-410/ NX-411) or the Square key (Mobile)
needs to be pressed.
In order to enter a Status Message or Short Message, the Menu
([ ]) or [*] key needs to be pressed. (Only if the transceiver
enters Individual Call Mode by a user pressing the Individual +
Status (NXDN) or Individual + SDM (NXDN) key or selecting
Individual + Status (NXDN) or Individual + SDM (NXDN) by a user
pressing the Menu key) (Refer to
Status Message (Status Call) on page
 Display during transmission
"CALLING" appears on the main display of the transceiver from when the transceiver initiates various call requests until
the call requests are determined.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
The following displays appear depending on the response message from the system after initiating various calls in an
NXDN Trunking system.
• If the transceiver receives a response message indicating the queue state from the system:
If the transceiver receives a response message indicating the queue state from the system, the Call Queue Tone
sounds from the transceiver and then the transceiver will enter the standby state.
However, it does not appear during a Status Call, Short Data Call and a Long Data Call.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
FUNC (K)/Ver 4.00
8.9 Sending and Receiving a
150.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
Mobile
Mobile
CONTENTS INDEX 207