Kenwood NEXEDGE NX-200 Function Reference page 412

14 DTMF
14.6 Using Autodial List
14.6 Using Autodial List
The following functions relevant to Autodial can be configured using KPG-111D/ DN:
• Autodial List
• Autodial Programming
Autodial List
Audio List is the list in which the DTMF code used for Autodial is configured.
Autodial List can be configured by using KPG-111D/ DN.
Configuration
DTMF Name A name can be assigned to the DTMF code. A maximum of 14 characters can be configured.
Code The DTMF code to be sent can be configured. A maximum of 16 numeric digits can be configured.
Configuration using KPG-111D/ DN
Configuring the Autodial List (
Editing the Autodial List with the Transceiver (Autodial Programming)
Data configured for Autodial List can be added, changed, or deleted by operating the transceiver.
Pressing the Autodial Programming key causes the transceiver to enter Autodial Programming Mode and then entries in
the Autodial List can be added, changed or deleted.
Or, the transceiver enters Autodial Programming Mode if "Autodial Programming" is selected after entering Menu Mode by
a user pressing the Menu key. (Refer to
Note
• While * and # key-entry Pattern is disabled, pressing the [*] or [#] key in Autodial Programming Mode directly enters the "*" or "#" tone.
In this case, A to D tones cannot be entered by pressing the [*] key, and the characters entered by pressing the [#] key cannot be
cleared.
• This function is unavailable for NX-200S/ NX-300S.
FUNC (K)/Ver 4.00
Table 14-8 Autodial List Configuration
FPRG 8.14.3 Autodial List Tab)
See
3.4 Using Menu Mode on page
Description
23.)
CONTENTS INDEX 378