Kenwood NEXEDGE NX-200 Function Reference page 352

12 FleetSync
12.4 Making a Selective Call
Configuration
Off Auto Reset Timer will not be activated.
1 s to 300 s After the time configured for Auto Reset Timer elapses, the matching state of the FleetSync ID is automatically reset.
If this function is enabled, the blinking orange BUSY LED for the Selective Call Alert LED turns Off when the time
LED
configured for the Auto Reset Timer elapses.
While this function is enabled, the intermittently emitted Alert Tone stops if the amount of time configured for Auto
Alert
Reset Timer elapses.
While this function is enabled, the matching state of the Selective Call is reset if the amount of time configured for
Monitor
Auto Reset Timer elapses.
While this function is enabled, the transceiver restores the previous channel display if the amount of time configured
for Auto Reset Timer elapses.
LCD
Note
This function is unavailable for NX-200S/ NX-300S.
Note
For NX-200S/ NX-300S, the Monitor configuration explained above is always enabled.
Configuration using KPG-111D/ DN
Configuring the Auto Reset Timer (
FUNC (K)/Ver 4.00
Table 12-9 Auto Reset Timer
Description
See FPRG 8.16.3 General 2 Tab)
CONTENTS INDEX 318