About Zones
Zone data in a Conventional Group, LTR Trunking System or NXDN Trunking System can be configured using KPG-111D/
DN.
In addition, zone data in a Conventional Group and zone data for Site Roaming and Site Roaming with RAN can be
configured as an NXDN Conventional system zone. (Refer to
Conventional Group (Analog Conventional System/ NXDN Conventional System)
A zone in an Analog Conventional system consists of Conventional Channels that are used for communicating in
analog mode.
A zone in an NXDN Conventional system consists of Conventional Channels that are used for communicating in digital
mode using the NXDN protocol.
LTR Trunking System
This zone consists of GIDs used for communicating using the LTR (Logic Trunked Radio) Trunking protocol.
NXDN Trunking System
This zone consists of GIDs used for communicating using the NXDN protocol.
The transceiver can be used in Single System or Multiple Systems.
Single System:
Only a single system can be used.
Multiple Systems:
The system to be used can be configured for each zone by selecting from system 1 to 8. A system can be switched
just by changing a zone.
Site Roaming
This zone consists of channels in an NXDN Conventional system in which Site Roaming is enabled.
Site Roaming with RAN
This zone consists of channels in an NXDN Conventional system in which Site Roaming is enabled.
For NX-200/ NX-210/ NX-300/ NX-410/ NX-411/ NX-700/ NX-700H/ NX-800/ NX-800H/ NX-900/ NX-901, a maximum of
128 zone data for Conventional Group, LTR Trunking System, NXDN Trunking System, Site Roaming and Site Roaming
with RAN in total can be configured for the transceiver. A maximum of 250 channels or GID data per zone can be
configured for the transceiver. A maximum of 512 channels or GID data can be configured for a transceiver in total.
For NX-200S/ NX-300S, a maximum of 4 zone data for Conventional Group, LTR Trunking System, NXDN Trunking
System, Site Roaming and Site Roaming with RAN in total can be configured for the transceiver.
A maximum of 16 channels or GID data per zone can be configured for the transceiver. A maximum of 64 channels or GID
data can be configured for a transceiver in total.
Note
• The number of zones that can be configured varies depending on the number of channels or GIDs and repeaters.
• The number of channels or GIDs that can be configured for each zone varies depending on the number of zones and repeaters.
FUNC (K)/Ver 4.00
8.14 Site Roaming on page
CONTENTS
173.)
INDEX
xiii