Warning Tone - Kenwood NEXEDGE NX-200 Function Reference

6 SOUND
6.1 Tones that Sound When a User Operates the Transceiver or When the Transceiver Status Is Changed
Function
OTAP Reactivation Tone
Call In Progress Tone
Disconnect Indication Tone

Warning Tone

Warning Tone is a tone that sounds from the transceiver before or when the transceiver is disabled to transmit, when the
transceiver becomes unable to transmit, or when the transceiver attempts to transmit while the transceiver is unable to
transmit.
Function
Warning Tone A
Warning Tone B
Warning Tone C
Battery Warning Tone
(Portable only)
TOT Pre-alert Tone
PLL Unlock Tone
Busy Tone
Busy Tone 2
Timed Power-off Pre-alert
Tone A (Mobile only)
Timed Power-off Pre-alert
Tone B (Mobile only)
Timed Power-off Pre-alert
Tone C (Mobile only)
FUNC (K)/Ver 4.00
This tone sounds from the transceiver only if pressing a key on the transceiver allows the transceiver to
be in OTAP Reactivation Mode.
This tone sounds at 500-millisecond intervals from the transceiver while pressing and holding the Side 2
key (Portable) or the Square key (Mobile) after the transceiver is turned ON and enters OTAP
Reactivation Mode by pressing and holding the Side 2 key (Portable) or Square key (Mobile).
Reactivation starts after an OTAP Reactivation Pre-alert Tone sounds from the transceiver for 5 times.
If the Side 2 key (Portable) or the Square key (Mobile) is released before an OTAP Reactivation Pre-
alert Tone sounds from the transceiver for 5 times, OTAP Reactivation Mode ends, and the transceiver is
activated in User Mode.
This tone sounds from the transceiver if the transceiver initiates a Telephone Call, Individual Call
(Message Trunked (Enhanced)), or Group Call (Message Trunked (Enhanced)) and the transceiver is
available for communications.
This tone sounds from the transceiver if the transceiver terminates communications with a Telephone
Call, Individual Call (Message Trunked (Enhanced)), or Group Call (Message Trunked (Enhanced)).
Table 6-4 Warning Tone
This tone sounds from the transceiver while an unprogrammed channel or GID is selected.
This tone sounds from the transceiver until the PTT switch is released if the transmission is terminated
by the Time-out Timer or the transceiver cannot transmit.
This tone sounds from the transceiver until the PTT switch is released while Busy Channel Lockout is
activated in a Conventional Group.
This tone sounds from the transceiver when the VOX transmission is terminated by Time-out Timer.
This tone sounds from the transceiver when the automatic transmission is terminated by Time-out Timer.
This tone sounds from the transceiver when the Battery voltage level drops to the adjusted reduced-
voltage level.
This tone sounds from the transceiver when the transmit inhibit period configured in the Time-out Timer
is about to expire.
This tone sounds from the transceiver when PLL is unlocked.
This tone sounds from the transceiver if there is no available repeater in an LTR Trunking system.
This tone sounds from the transceiver if the transceiver cannot send data to a Conventional Group since
the channel is busy.
This tone sounds from the transceiver when the transceiver receives a response message from the
system that notifies of the busy state of the receiving transceiver in an NXDN Trunking system.
This tone sounds from the transceiver 1 min before the time preconfigured for Timed Power-off.
This tone sounds from the transceiver 10 sec before the time preconfigured for Timed Power-off.
This tone sounds from the transceiver 2 sec before the time preconfigured for Timed Power-off.
Description
Description
CONTENTS INDEX 87