Kenwood NEXEDGE NX-200 Function Reference page 347

12 FleetSync
12.4 Making a Selective Call
Receiving a Selective Call
Conditions for the FleetSync ID to match are as follows:
Note
To receive a Selective Call, "FleetSync" must be configured for the Optional Signaling used by the channel or GID. (Refer to
Optional Signaling (Analog) on page
Transceiver Behavior
1
The transceiver receives a Selective Call.
The Alert Tone (Individual Call or Other Selective Calls) sounds
from the transceiver and then the ID Name of the transmitting
transceiver will appear.
The transceiver can respond to the received ID by a user
pressing the PTT switch. When a key other than the PTT switch
is pressed, the configured function will be activated. However,
functions that can be used are limited. When an invalid key is
pressed, the Key Beep B sounds, and then the display will restore
to normal state. Refer to
available functions.
FUNC (K)/Ver 4.00
Table 12-5 Conditions to Unmute the Speaker
Conditions to Unmute the Speaker
Call Type
Fleet
fff: 100 to 349
Individual Call Match
Group Call Match
Fleet Call Match
Supervisor Call ALL Fleet
Broadcast Call ALL Fleet
261, 11.2 Using the Optional Signaling (LTR) on page
Mode Reset Timer on page 20
ID
iiii: 1000 to 4999
Match
Group ID matches
ALL ID
Match
ALL ID
285.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for the
Mobile
CONTENTS INDEX
Using the
313