Kenwood NEXEDGE NX-200 Function Reference page 525

22 FUNCTION PORTS
22.3 Assigning Functions to the Internal Connector (OPT1/ OPT11)
DEO Level
DEO Level is the output signal level of the DEO port available on the D-sub 25-pin connector of the transceiver. The output
signal level can be optimized according to the devices that are connected to the transceiver.
Configuration using KPG-111D/ DN
• Configuring the DI Level (
• Configuring the DEO Level (
22.3 Assigning Functions to the Internal Connector (OPT1/ OPT11)
OPT is the function port of the 26-pin connector in the transceiver.
The following functions can be assigned to pin 1 and pin 18 of the 26-pin connector depending on the usage of the user by
installing the ANI board in the transceiver via the 26-pin connector.
Function
None No function is activated. The OPT port is in input mode.
COR The OPT port is activated when the transceiver receives a carrier.
In the case of Conventional Zone (Analog):
If the received QT tone or DQT code matches the QT tone or DQT code preconfigured for the transceiver, the
OPT port becomes active. If the QT tone or DQT code is not configured, the OPT port becomes active when the
transceiver receives a carrier.
In the case of Conventional Zone (NXDN):
If the received RAN code matches the RAN code preconfigured for the transceiver, the OPT port becomes active.
TOR If no RAN code is configured for the transceiver, the received any RAN code is deemed to be matched, and the
OPT port becomes active.
In the case of Conventional Zone (Mixed):
If the received QT tone, DQT code, or RAN code matches the QT tone, DQT code, or RAN code preconfigured for
the transceiver, the OPT port becomes active.
In the case of LTR Trunking Zone:
If the received Group ID matches the Group ID preconfigured for the transceiver, the OPT port becomes active.
In the case of Conventional Zone:
LOK If the transceiver starts transmission, the OPT port becomes active.
(Continuous) In the case of LTR Trunking Zone:
If the transceiver is linked with a repeater while transmitting, the OPT port becomes active.
Note
This function is available only in a Conventional Zone (Analog, NXDN) or LTR Trunking Zone. No function is activated in an NXDN
Trunking Zone even if a function is configured.
Configuration using KPG-111D/ DN
• Configuring the OPT1 (
• Configuring the OPT11 (
FUNC (K)/Ver 4.00
See FPRG 8.30.5 Mobile Function Tab)
See FPRG 8.30.5 Mobile Function Tab)
Table 22-11 OPT1, OPT11
FPRG 8.29.2 OPT1 and 8.30.1 Optional Board Tab)
See
FPRG 8.29.3 OPT11 and 8.30.1 Optional Board Tab)
See
Description
CONTENTS INDEX 491