Kenwood NEXEDGE NX-200 Function Reference page 346

12 FleetSync
12.4 Making a Selective Call
2
Press and hold the
The Selcall ID entry display appears.
Pressing the Left key will also show the entry display of the
Selcall ID.
3
Enter the ID.
Refer to Entering or Deleting a Code on page 48
methods.
 Using the PF keys
The characters can be selected by pressing the Up or Down
key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), or by
pressing the [ ] or [ ] key (Mobile), and the selected
characters can be determined by pressing the Menu ([
[*] key.
 Using the keypad
A code can be entered by pressing the [0] to [9] keys.
4
Press the PTT switch to initiate a Voice Call.
In order to initiate a Paging Call, the Side 2 key (NX-200/
NX-210/ NX-300/ NX-410/ NX-411) or the Square key (Mobile)
needs to be pressed.
Press the Menu ([ ]) or [*] key to enter the Status Message or
Short Message. (Only if the transceiver enters Selcall Mode by a
user pressing the Selcall + Status (FleetSync) or Selcall + SDM
(FleetSync) key or selecting Selcall + Status (FleetSync) or
Selcall + SDM (FleetSync) by pressing the Menu key.) (Refer to
12.6 Sending and Receiving a Status Message (Status Call) on
page 323.)
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Assigning functions to the Keypad Operation on the transceiver (
• Configuring the Manual Dialing to be enabled or disabled (
FUNC (K)/Ver 4.00
Menu ([ ]) or [*] key.
for entry
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
]) or
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
See FPRG 8.12 Key Assignment Window)
See FPRG 8.12.2 General Tab)
See FPRG 8.16.2 General 1 Tab)
CONTENTS
Mobile
Mobile
INDEX 312