Kenwood NEXEDGE NX-200 Function Reference page 323

11 LTR TRUNKING SYSTEM
11.4 Restricting the ID (Block ID)
11.4 Restricting the ID (Block ID)
Block ID can be used to restrict use of IDs.
This function can be used to specify the range of the IDs used to communicate with a telephone, IDs that cannot be used
immediately after the transceiver receives a call, and receive-only IDs.
ID Used When Communicating on a Telephone (Telephone ID)
Telephone ID is an ID used to communicate with a telephone. A call can be initiated from the transceiver to a telephone,
and from a telephone to the transceiver.
Configuration using KPG-111D/ DN
Configuring the Telephone ID (
Inhibiting Response Immediately After Receiving ID (Transmit Inhibit)
Transmit Inhibit can be used to restrict a user from initiating a call using the received ID immediately after the transceiver
receives a specific ID.
This can be used to restrict using an ID immediately after receiving the ID if Group ID is shared and used by multiple
parties.
The transceiver cannot transmit until the length of time configured for Transmit Inhibit Time elapses after receiving the
Transmit Inhibit ID.
Transmit Inhibit ID and Transmit Inhibit Time can be configured using KPG-111D/ DN. This function can be configured for
each user.
Note
• If the zone or Group ID is changed, the state preventing transmission is reset and transmission can resume.
• If the transceiver receives a Transmit Inhibit ID during a scan, the transceiver cannot transmit until the time configured in Transmit
Inhibit Time elapses after receiving the call. Transmit Inhibit Time is reset and a transmission can be started when the transceiver
resumes scanning.
• If the transceiver receives a Transmit Inhibit ID when connected to a repeater, the transceiver cannot transmit before the length of time
configured for Transmit Inhibit Time elapses.
Configuration using KPG-111D/ DN
• Configuring the Transmit Inhibit ID (
• Configuring the Transmit Inhibit Time (
ID Dedicated for Reception (Decode ID)
Decode ID is an ID dedicated for reception by restricting a user from transmitting using the ID. The transceiver emits the
received audio if the transceiver receives a call using the Decode ID.
Configuration using KPG-111D/ DN
Configuring the Decode ID (
FUNC (K)/Ver 4.00
FPRG 8.6.20 Telephone (Block ID))
See
See FPRG 8.6.21 Transmit Inhibit (Block ID))
FPRG 8.11.2 LTR Tab)
See
See FPRG 8.6.22 Decode (Block ID))
CONTENTS INDEX 289