Kenwood NEXEDGE NX-200 Function Reference page 304

10 ANALOG CONVENTIONAL SYSTEM
10.4 Using 2-tone to Initiate a Selective Call
Operating the Transceiver
1
Press the 2-tone key.
The 2-tone Encode Memory List appears.
2
Press the Up or Down
NX-800/ NX-800H) to select the target data from 2-tone Encode List.
Refer to Selecting or Clearing Data from a List on page 42
selection methods.
3
Select one of the following operations.
• In order to send the 2-tone code and initiate voice calls, press the PTT switch.
• To send only the 2-tone code, press the Side 2 (NX-200/ NX-210/ NX-300) or the Square key (NX-700/ NX-700H/ NX-800/
NX-800H).
The transceiver sends the 2-tone code.
Note
If "QT/DQT and Optional Signaling" is configured for Audio Control, the transceiver will abort the standby mode for Optional Signaling
after the transceiver transmits. The Transmit LED blinks orange when the transceiver finishes transmitting. (Refer to
Speaker (Audio Control (Analog)) on page
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (
FUNC (K)/Ver 4.00
key (NX-200/ NX-210/ NX-300), or press the
261.)
See
NX-200/ NX-210/ NX-300
NX-700/ NX-700H/ NX-800/ NX-800H
[ ] or [ ]
for
NX-200/ NX-210/ NX-300
NX-700/ NX-700H/ NX-800/ NX-800H
FPRG 8.12 Key Assignment Window)
CONTENTS
key (NX-700/ NX-700H/
Unmuting the
INDEX 270