Kenwood NEXEDGE NX-200 Function Reference page 239

9 NXDN TRUNKING SYSTEM
9.5 Making an Individual Call (Transmission Trunked)
Operating the Transceiver
 Initiating an Individual Call by list selection
1
Press the Individual
The transceiver enters Individual Call Mode and then the Unit ID
List selection display will appear.
The following operations are identical even if the transceiver
enters Individual Call Mode by a user pressing the Menu key or
using the keypad.
2
Press the Up or Down
to select a Unit ID from the Unit ID List.
Refer to Selecting or Clearing Data from a List on page 42
selection methods.
3
Press the PTT switch to initiate a Voice Call.
In order to initiate a Paging Call, the Side 2 key (NX-200/
NX-210/ NX-300/ NX-410/ NX-411) or the Square key (Mobile)
needs to be pressed.
In order to enter a Status Message or Short Message, the Menu
([ ]) or [*] key needs to be pressed. (Only if the transceiver
enters Individual Call Mode by a user pressing the Individual +
Status (NXDN) or Individual + SDM (NXDN) key or selecting
Individual + Status (NXDN) or Individual + SDM (NXDN) by a user
pressing the Menu key) (Refer to
Status Message (Status Call) on page
FUNC (K)/Ver 4.00
(NXDN), Individual + Status
key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), or press the
8.9 Sending and Receiving a
150.)
(NXDN), or Individual + SDM (NXDN)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
key.
Mobile
[ ] or [ ] key (Mobile)
Mobile
INDEX 205