Kenwood NEXEDGE NX-200 Function Reference page 281

9 NXDN TRUNKING SYSTEM
9.20 Sending GPS Data
Configuration using KPG-111D/ DN
• Configuring the Base ID Type and the Base ID (Single System) (
• Configuring the Base ID Type (GPS) and Base ID (GPS) (Single System) (
• Configuring the Base ID Type and the Base ID (Multiple Systems) (
• Configuring the Base ID Type (GPS) and the Base ID (GPS) (Multiple Systems) (
Sending GPS Data on a Channel in an NXDN Conventional System
(GPS Data Zone-Channel)
The GPS Data Zone-Channel is the zone and channel in a Conventional Group that is used for sending GPS data in an
NXDN Trunking system. To use a GPS Data Zone-Channel, "Conventional Channel" needs to be configured for the GPS
Report Channel Type.
If "Conventional Channel" has been configured for GPS Report Channel Type, the transceiver automatically migrates to
the GPS Data Zone- Channel corresponding to the current site so as to send the GPS data at the time of sending GPS
data. After sending the GPS data, the transceiver restores the previous GID in an NXDN Trunking system.
Also, only a channel in an NXDN Conventional system can be configured for the GPS Data Zone-Channel.
GPS Report CH Type
The GPS Report CH Type is the channel type in an NXDN Trunking system that is used by the transceiver to automatically
send GPS data including polling.
The transceiver can use a control channel, traffic channel or channel in an NXDN Conventional system to automatically
send GPS data including polling.
The transceiver behaves as follows depending on the configuration for the GPS Report CH Type.
Configuration
Control Channel The GPS data is automatically sent on a control channel in the current site including polling.
The GPS data is automatically sent on a traffic channel in the current site as a Long Data Message including
Traffic Channel
polling.
The GPS data including polling is automatically sent on the zone and channel configured for GPS Data Zone-
Conventional Channel. The zone and channel corresponding to the current site number are applied. The transceiver
Channel automatically migrates to a GPS Data Zone-Channel corresponding to the current site to send the GPS data at
the time of sending GPS data.
Configuration using KPG-111D/ DN
• Configuring the GPS Data Zone-Channel (
• Configuring the GPS Report CH Type (
FUNC (K)/Ver 4.00
Table 9-10 Configuration for GPS Report CH Type
FPRG 8.8.17 GPS Data Zone-Channel Window)
See
See FPRG 8.19.4 Trunking Tab)
See FPRG 8.19.2 General 1 Tab)
See FPRG 8.19.10 GPS Tab)
FPRG 8.20.3 General Tab)
See
See
Description
CONTENTS
FPRG 8.20.3 General Tab)
INDEX 247