Kenwood NEXEDGE NX-200 Function Reference page 169

8 NXDN CONVENTIONAL SYSTEM
8.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Individual Call
Initiating an Individual Call (Individual Call Acknowledge Request)
An Individual Call (Individual Call Acknowledge Request) can be activated by one of the following methods.
 Individual Call Mode
Selecting a Unit ID configured in the Unit ID List or directly entering a Unit ID while the transceiver is in Individual Call
Mode, and then pressing the PTT switch or the Side 2 key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411) or the Square
key (Mobile) sends a message requesting an acknowledgment.
Pressing the Individual (NXDN), Individual + Status (NXDN), or Individual + SDM (NXDN) key places the
transceiver in Individual Call Mode.
The transceiver also enters Individual Call Mode by a user selecting "Individual (NXDN)", "Individual + Status (NXDN)",
or "Individual + SDM (NXDN)" after the transceiver enters Menu Mode by a user pressing the Menu key. (Refer to
Using Menu Mode on page
Or, pressing the [0] to [9] keys on the keypad causes the transceiver to enter Individual Call Mode if "Individual
(NXDN)", "Individual + Status (NXDN)" or "Individual + SDM (NXDN)" is configured for Keypad Operation. The
transceiver enters Unit ID Shortcut Entry Mode or will be on hold as the first digit of the Unit ID is entered. (Refer to
Keypad Operation on page
 Stack Mode
Selecting a call record in Stack Mode and then pressing the PTT switch sends a message requesting an
acknowledgment.
Pressing the Stack key places the transceiver in Stack Mode. Or, pressing the Menu key causes the transceiver to
enter Menu Mode, and then selecting "Stack" will cause the transceiver to enter Stack Mode.
 Selcall on PTT
Selecting the channel where the target Unit ID for Selcall on PTT is configured and then pressing the PTT switch sends
a message requesting an acknowledgment. The Unit ID of the target transceiver can be configured by selecting one
Unit ID from the Unit ID List by using KPG-111D/ DN.
 Call key
Pressing one of the Call 1 key to the Call 6 key sends a message requesting an acknowledgment to the Unit ID
allocated to the key pressed. A Unit ID must be configured to the Call 1 key to the Call 6 key so as to initiate a call to
the specified Unit ID when one of the Call 1 key to the Call 6 key is pressed.
Note
• An Individual Call (Individual Call Acknowledge Request) cannot be initiated by using a PC command.
• For NX-200S/ NX-300S, the transceiver cannot initiate an Individual Call (Individual Call Acknowledge Request) using Individual Call
Mode or Stack Mode.
Operating the Transceiver
1
Follow one of the methods mentioned above to initiate an Individual Call (Individual Call Acknowledge
Request).
A message requesting an acknowledgment is sent.
FUNC (K)/Ver 4.00
23.)
21.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX
3.4
135