Kenwood NEXEDGE NX-200 Function Reference page 460

18 DATA COMMUNICATION FUNCTIONS
18.2 Data Zone-CH/GID/ 18.3 Multiplexing QT/DQT during Data Transmission (Data Transmit with QT/DQT)
18.2 Data Zone-CH/GID
Data Zone-CH/GID is the data channel or GID having the highest priority when the transceiver migrates to a data channel
or GID.
If the following functions are enabled, the transceiver sends the message or data after migrating to the Data Zone-channel
or GID configured in the selected zone when the transceiver sends a Status Message, Short Message, Long Message,
GPS data or Transparent data:
• Status Message on Data Zone-CH/GID
• Short Message on Data Zone-CH/GID
• Long Message on Data Zone-CH/GID
• GPS Report on Data Zone-CH/GID
• Transparent on Data Zone-CH/GID
When the transmission ends, the transceiver reverts to the previous Zone-channel or GID.
Note
• This function can be used only in a Conventional Group and LTR Trunking system.
• For Mobile, the transceiver migrates to the analog channel or GID configured for Data Zone-CH/GID (Analog) when the Data PTT or
DTC port becomes active. In an NXDN Trunking system, the transceiver also migrates according to these port states to the analog
channel or GID configured for Data Zone-CH/GID (Analog) in an NXDN Trunking system zone. (Refer to
Input Ports on page 481.)
Configuration using KPG-111D/ DN
• Configuring the Data Zone-CH/GID (Conventional Group) (
Data Zone-CH/GID (NXDN))
• Configuring the Data Zone-CH/GID (LTR Trunking System) (
• Configuring the Data Zone-CH/GID (NXDN Trunking System) (
18.3 Multiplexing QT/DQT during Data Transmission
(Data Transmit with QT/DQT)
Data Transmit with QT/DQT is the function to be used to multiplex the QT tone or DQT code configured for channels
during data transmission.
This function is available on the channels in the Conventional Group that send a Status Message, Short Message or Long
Message. This function is also used for data communications by use of an external device.
If QT tone or DQT code is used by repeaters, enabling this function allows the data communications with the QT tone or
DQT code multiplexed.
If data communication and a voice call are established on the same channel, the data transmission sound can be muted
during data communication without multiplexing the QT tone or DQT code by disabling this function.
Note
This function can be only used in an Analog Conventional system.
Configuration using KPG-111D/ DN
Configuring the Data Transmit with QT/DQT (
FUNC (K)/Ver 4.00
FPRG 8.2.2 Data Zone-CH/GID (Analog) and 8.2.3
See
See FPRG 8.6.4 Data Zone-CH/GID (Analog))
See FPRG 8.8.2 Data Zone-CH/GID (Analog))
See FPRG 8.16.4 Parameter Tab)
Available Functions for AUX
CONTENTS INDEX 426