Kenwood NEXEDGE NX-200 Function Reference page 423

15 GPS
15.2 GPS Position Display
Configuring the GPS Position Display
The functions below relevant to GPS Position Display can be configured using KPG-111D/ DN. The functions must be
configured in the following order.
1) Communication port
"GPS" needs to be assigned to the communication port of the transceiver. Stop Bit and Baud Rate must be configured
if needed. (Refer to Available Functions for COM Port on page
2) PF key
GPS Position Display needs to be assigned to a key on the transceiver. (Refer to
on page 510.)
Pressing the GPS Position Display key causes the transceiver to enter GPS Position Display Mode.
The transceiver also enters GPS Position Display Mode if "GPS Position Display" is selected after entering Menu Mode
by pressing the Menu key. (Refer to
3) Configuring displays in GPS Position Display Mode
• Latitude and Longitude
This function can be used to configure whether the latitudinal and longitudinal values appear on the transceiver
main display. If this function is enabled, latitudinal and longitudinal values appear on the transceiver main display in
GPS Position Display Mode. The latitude and longitude display format can be selected from "Degrees, Minutes" and
"Degrees, Minutes, Seconds" for user convenience.
If this function is disabled, the latitudinal and longitudinal values do not appear in GPS Position Display Mode.
• Altitude
This function can be used to configure whether the altitudinal value will appear on the transceiver main display. If
this function is enabled, the altitudinal value appears on the transceiver main display in GPS Position Display Mode.
Either "Meters" or "Feet" can be configured for the format to display an altitudinal value for user convenience.
If this function is disabled, no altitudinal value appears in GPS Position Display Mode.
• Sub-LCD Display
If "GPS Status" is configured for Sub-LCD Display, the GPS positioning status ("GPS" or "---") always appears on
the sub-display of the transceiver. This function allows a user to check the receiving status for GPS while the normal
channel display appears on the main display.
Configuration using KPG-111D/ DN
• Configuring the COM port (
• Assigning functions to the PF keys on the transceiver (
• Configuring the Latitude and Longitude (
• Configuring the Altitude (
• Configuring the Sub-LCD Display (
FUNC (K)/Ver 4.00
3.4 Using Menu Mode on page
See FPRG 8.10.3 Common Page 3 Tab)
See FPRG 8.11.4 GPS Tab)
See FPRG 8.11.4 GPS Tab)
See FPRG 8.10.1 Common Page 1 Tab)
524.)
Available Functions for the PF Keys
23.)
See FPRG 8.12 Key Assignment Window)
CONTENTS INDEX 389