Kenwood NEXEDGE NX-200 Function Reference page 411

14 DTMF
14.5 Functions Related to DTMF Code Decoding
Auto Reset Timer
Auto Reset Timer allows you to configure the amount of time from when the received DTMF code matches the DTMF code
preconfigured for the transceiver until the matching status is automatically reset.
By using KPG-111D/ DN, Auto Reset Timer can be configured. Also, how the transceiver behaves after the amount of time
configured for Auto Reset Timer elapses can be configured.
Configuration
Off Auto Reset Timer will not be activated.
1 s to 300 s After the time configured for Auto Reset Timer elapses, the matching state of the DTMF code is automatically reset.
If this function is enabled, the blinking orange BUSY LED for the Selective Call Alert LED turns Off when the time
LED
configured for the Auto Reset Timer elapses.
While this function is enabled, the intermittently emitted Alert Tone stops if the amount of time configured for Auto
Alert
Reset Timer elapses.
While this function is enabled, the matching state of the DTMF code is reset if the amount of time configured for Auto
Monitor
Reset Timer elapses.
Note
For NX-200S/ NX-300S, the Monitor configuration explained above is always enabled.
Configuration using KPG-111D/ DN
Configuring the Auto Reset Timer (
Clear to Transpond
Clear to Transpond is the function that allows the transceiver to wait the Transpond operation until the channel is no longer
in use if the channel is occupied by other users when the transceiver attempts to initiate the Transpond operation.
Note
This function can be used only in a Conventional Group.
Configuration using KPG-111D/ DN
Configuring the Clear to Transpond to be enabled or disabled (
FUNC (K)/Ver 4.00
Table 14-7 Auto Reset Timer
Description
See FPRG 8.14.2 Decode Tab)
FPRG 8.14.2 Decode Tab)
See
CONTENTS INDEX 377