Rollover/ End Stop - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS
3.5 Changing the Zone-channel or GID
Mobile
Pressing the CH/GID Up key increases the channel or GID number in steps of 1. Pressing the CH/GID Down key
decreases the channel or GID number in steps of 1.
If "CH/GID Up (Continuous)" or "CH/GID Down (Continuous)" is assigned to the CH/GID Up or CH/GID Down key, the
channel or GID number will be increased or decreased continuously every 200 ms by pressing and holding the CH/GID Up
or CH/GID Down key.
If an unprogrammed channel or GID is selected, the channel or GID will be skipped.
Note
Operation for changing the channel or GID varies depending on the configuration for Rollover/ End Stop. (Refer to
Stop on this page.)
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Configuring the 16 Zone/Channel Selector to be enabled or disabled (

Rollover/ End Stop

Rollover/ End Stop allows you to configure how the zone, channel or GID migrates when changing the zone, channel or
GID using the PF keys or Selector on the transceiver.
The zone, channel or GID migrates as below depending on the configuration using KPG-111D/ DN when changing the
zone, channel or GID using the PF keys or Selector on the transceiver.
Configuration
The Rollover Tone sounds from the transceiver and the transceiver will migrate to the zone or channel or GID having
the lowest number when a user attempts to increase the zone, channel or GID number while the zone or channel or
ID having the largest number is selected.
The transceiver will migrate to the zone or channel or GID having the largest number when a user attempts to
decrease the zone, channel or GID number while the zone or channel or GID having the lowest number is selected.
Rollover
Note
If a zone is changed in NX-200S/ NX-300S, a Zone Select Tone sounds from the transceiver, but no Rollover Tone
will sound. However, if Zone-CH/GID Guide for the VGS-1 unit is used, a Zone Select Tone will not sound from the
transceiver, but a Rollover Tone will sound. (Refer to
Zone, channel or GID in the range between the highest and lowest numbers can be selected. Zone, channel or GID
number is not looped. The Stop Tone sounds from the transceiver and the transceiver will not migrate to another
zone or channel or GID even if a user attempts to increase the zone, channel or GID number while the zone or
End Stop
channel or GID having the highest number is selected. The Stop Tone sounds from the transceiver and the
transceiver will not migrate to another zone or channel or GID even if a user attempts to decrease the zone, channel
or GID number while the zone or channel or GID having the lowest number is selected.
Configuration using KPG-111D/ DN
Configuring the Rollover/End Stop (
FUNC (K)/Ver 4.00
See
Table 3-5 Rollover/ End Stop
Description
See FPRG 8.10.1 Common Page 1 Tab)
FPRG 8.12 Key Assignment Window)
See FPRG 8.12.2 General Tab)
Using the Voice Guide (Voice Guide) on page
CONTENTS
Rollover/ End
470.)
INDEX 28