Kenwood NEXEDGE NX-200 Function Reference page 298

10 ANALOG CONVENTIONAL SYSTEM
10.2 Using the Signaling
2
Release the Monitor Momentary
The " " icon disappears. A channel where QT/DQT Decode is
configured resumes Signaling Squelch.
Note
Pressing the Monitor key or the Monitor Momentary key while the Optional Signaling matches resets the matching state of the
Optional Signaling.
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (
Transceiver Behavior during the Scan
In a Conventional Group, the transceiver resets the signaling and unmutes only with a carrier, and then remains in the
standby state.
Pressing the Monitor key during the scan causes the "
appears, the transceiver uses Carrier Squelch in the same manner as when the scan is deactivated.
Pressing and holding the Monitor Momentary key during the scan causes the transceiver to enable the Carrier Squelch in
the same manner as when the scan is deactivated, and the scan continues. Pressing the Monitor Momentary key never
causes the scan to be deactivated.
Unmuting the Speaker by Linking with the Microphone (Off-hook Decode)
(Mobile Only)
Off-hook Decode can be used to disable QT tone or DQT code and Optional Signaling linked with a microphone on- or off-
hook state, and unmute by a Carrier Squelch.
The transceiver behaves as follows according to the configuration for Off-hook Decode.
Configuration
The transceiver opens the squelch according to the configuration for Audio Control while the microphone is in
Enabled
either the on-hook state or off-hook state.
The transceiver unmutes the speaker when the transceiver receives a carrier if the microphone is in the off-hook
state.
Disabled
The transceiver opens squelch according to the configuration for Audio Control if the microphone is in the on-
hook state.
Note
• If "Mixed" is configured for Channel Type, the transceiver behavior varies according to the type of a received signal (Analog or NXDN).
• Stun can be activated regardless of the status of Off-hook Decode and the microphone on- or off-hook state.
• The matching state of Optional Signaling will be reset by hooking the microphone on a hanger (On-hook state) after receiving a call by
Optional Signaling.
FUNC (K)/Ver 4.00
key.
FPRG 8.12 Key Assignment Window)
See
" icon to appear and the scan to continue. While the "
Table 10-5 Off-hook Decode
Description
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX
" icon
264