Kenwood NEXEDGE NX-200 Function Reference page 245

9 NXDN TRUNKING SYSTEM
9.5 Making an Individual Call (Transmission Trunked)
Unit ID List
The transceiver uses an individual Unit ID to establish communication if using the NXDN function. The desired Unit IDs
must be preconfigured in the transceiver using KPG-111D/ DN prior to use of the transceiver. A maximum of 1000 Unit IDs
can be configured for Unit ID List.
Unit ID List is commonly used in an NXDN Conventional system and NXDN Trunking system.
Configuration
A Unit ID can be configured in the range between 1 and 65519. However, an ID having the number of 60001 or
ID
larger cannot be used in an NXDN Trunking system.
The caller's ID Name is configured. A maximum of 14 characters can be configured for the ID Name.
If the ID Name of the transmitting transceiver is registered in the ID List, the ID Name appears on the main
display when the transceiver receives a call.
ID Name After that, the received Unit ID Name appears upon receipt of the Unit ID Name by Over-the-Air Alias while
receiving a call. If the transceiver cannot receive the Unit ID Name, the stored ID Name appears if the ID Name
is stored for the Unit ID stored in the transceiver. The Unit ID number appears if the above conditions are not
satisfied.
The permission or inhibition of transmission of the receiving party can be configured.
An ID for which "Yes" is configured for Transmit Inhibit does not appear on the ID selection display in Individual
Call Mode, and a user cannot select the ID in Individual Call Mode.
Transmit Inhibit
If the transceiver receives a call from an ID for which "Yes" is configured for Transmit Inhibit, the caller's ID Name
appears on the main display. In this case, a user cannot initiate a call to the party even if the user attempts to
respond by pressing the PTT switch.
Individual The type of tone sounding from the transceiver can be configured for a Individual Call from the Unit IDs
(Alert Tone) registered in the Unit ID List.
The type of tone sounding from the transceiver can be configured for a Paging Call, an Individual Call (Message
Trunked (Enhanced)) and an Individual Call (Individual Call Acknowledge Request) from the Unit IDs registered
in the Unit ID List.
However, if receiving an Individual Call (Message Trunked (Enhanced)) or an Individual Call (Individual Call
Paging (Alert Tone)
Acknowledge Request) with the Automatic Response disabled, the configuration for Paging will apply.
Note
Individual Call (Individual Call Acknowledge Request) can be used only in an NXDN Conventional system.
Note
• In multiple systems, Unit ID List can be configured for each system.
• This function can be used with the Individual Call (Message Trunked (Enhanced)).
Configuration using KPG-111D/ DN
• Configuring the Unit ID List (Single System) (
• Configuring the Unit ID List (Multiple Systems) (
FUNC (K)/Ver 4.00
Table 9-5 Unit ID List
Description
See FPRG 8.19.6 Unit ID List Tab)
FPRG 8.20.4 Unit ID List Tab)
See
CONTENTS INDEX 211