Kenwood NEXEDGE NX-200 Function Reference page 270

9 NXDN TRUNKING SYSTEM
9.15 Using DTMF to Initiate a Selective Call/ 9.16 Locking the Site to Be Used (Site Lock/ Site Select)
9.15 Using DTMF to Initiate a Selective Call
DTMF Encode and the related functions can be used in an NXDN Trunking system. However, the PTT ID function is
unavailable.
DTMF is used when connecting to a telephone line, such as PSTN and PABX, and making voice communication in an
NXDN Trunking system. (Refer to
Also, the DTMF code can be sent during the transmission of Individual Calls or Group Calls by pressing one of the [0] key
to [9] key, the [*] key or the [#] key while pressing and holding the PTT switch.
Refer to 14 DTMF on page 359
9.16 Locking the Site to Be Used (Site Lock/ Site Select)
Site Lock can be used to lock the site to be used as the current site and prevent the transceiver from roaming to other sites
by a user operating transceiver keys when the transceiver is used around the border of the site coverage area. If this
function is enabled, the transceiver is locked on the current site and cannot roam.
A site can be selected in Site Select Mode or using the Selector or PF keys, and then the transceiver can be locked on the
selected site. To select a site, site information must be configured using KPG-111D/ DN. Or, the following functions must
be assigned to the Selector and PF keys in order to select a site using the Selector or PF keys.
Key Function
Site Up/Down
*1
Selector
Site Select
Site Up
Site Up (Continuous)
PF key
Site Down
Site Down (Continuous)
*1
Portable only
Note
Site Select Mode is unavailable for NX-200S/ NX-300S.
FUNC (K)/Ver 4.00
9.14 Communicating with a Telephone (Telephone Call) on page
for details about DTMF.
Table 9-9 Site Select
Available Functions for the Selector (Portable Only) on page 523
Available Functions for the PF Keys on page 510
233.)
Reference
CONTENTS INDEX 236