Kenwood NEXEDGE NX-200 Function Reference page 167

8 NXDN CONVENTIONAL SYSTEM
8.5 Making an Individual Call
Note
• If the transceiver receives an individual call using NXDN ID, the caller's ID appears. If the transceiver receives a group call using
NXDN ID, the message appears according to the configuration for Group Call Display Type. (Refer to
Receives a Group Call (Group Call Display Type) on page
• Caller ID Display is the function to display the caller information while communicating with the caller. Therefore, a user cannot reply to
the displayed Unit ID or Group ID, unlike an individual call or group call using NXDN ID.
• The transceiver can acquire the log data of operating time by sending information of the received Unit ID to a PC. In this case, a
separate application program is required.
• This function can be used with the Individual Call (Individual Call Acknowledge Request).
• This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Caller ID Display (
Restricting IDs for Which the Transceiver Can Initiate a Call (Unit ID Encode Block)
Unit ID Encode Block is the Unit ID range used to initiate a call.
A Unit ID with which a user is allowed to initiate a call can be restricted using KPG-111D/ DN. A user can use the Unit ID
stored in the Unit ID List even if it is outside the Unit ID Encode Block range.
The transceiver for which no Unit ID Encode Block is configured can initiate a call to all transceivers.
The transceiver disables the squelch and emits received audio when the transceiver receives an individual call. In this
case, the Unit ID of the transmitting transceiver appears on the receiving transceiver. The receiving transceiver can
respond to the transmitting transceiver by pressing the PTT switch. However, the transceiver cannot respond if initiating a
call to the Unit ID of the transmitting transceiver is restricted.
Note
• This function can be used with the Individual Call (Individual Call Acknowledge Request).
• If the transceiver is operated in multiple systems of an NXDN Trunking system, Unit ID Encode Block configured in the Home System
is used. (Refer to 9 NXDN TRUNKING SYSTEM on page
Configuration using KPG-111D/ DN
Configuring the Unit ID Encode Block (
Sending the Received Unit ID from the Communication Port (Unit ID Serial Output)
Unit ID Serial Output can be used to send the received Unit ID from the transceiver's communication port.
With the Unit ID Serial Output enabled, the dispatcher can monitor and control in real time transceivers that are
transmitting. The Unit ID sent from the communication port can also be used for management of the call log.
Note
• To use the Unit ID Serial Output, "Data" or "Data + GPS Data Output" must be assigned to the communication port of the transceiver.
• For an NXDN system, the same Unit ID may be sent multiple times for one transmission depending on the reception conditions of the
receiving party.
• If the transceiver receives a Group Call from a telephone, the transceiver will send an ID dedicated to the telephone (U65521
(0xFFF1)) from the communication port.
• This function can be used with the Individual Call (Individual Call Acknowledge Request).
Configuration using KPG-111D/ DN
Configuring the Unit ID Serial Output (
FUNC (K)/Ver 4.00
144.)
See FPRG 8.19.5 Conventional Tab)
187.)
See FPRG 8.19.2 General 1 Tab)
FPRG 8.10.6 Common Page 4 Tab)
See
Display When the Transceiver
CONTENTS INDEX 133