Installing An Ac Power Supply In An Ex8200 Switch - Juniper EX8208 Hardware Manual

5. Turn the adjustment nut of the power cord retainer counterclockwise till you can see the power cord.
Pull the power cord from the slot in the adjustment nut.
6. Squeeze the two sides of the power cord retainer clip, and pull the L-shaped ends of the clip from the
holes on each side of the AC appliance inlet to completely remove the power retainer clip.
7. Unscrew the captive screw counterclockwise using the Phillips (+) screwdriver, number 1.
8. Pull the captive screw away from the faceplate of the power supply to release the latch.
9. Pull the handle away from the faceplate of the power supply until it is perpendicular to the faceplate.
10. Taking care not to touch power supply components, pins, leads, or solder connections, place one hand
under the power supply to support it. Grasp the power supply handle with your other hand and pull
the power supply completely out of the chassis.
11. If you are not replacing the power supply, install the cover panel over the slot, using the Phillips (+)
screwdriver to tighten the screw on the side of the cover panel.
Figure 68: Removing an AC Power Supply from an EX8200 Switch

Installing an AC Power Supply in an EX8200 Switch

The AC power supply in an EX8200 switch is a hot-insertable and hot-removable field-replaceable unit
(FRU). Up to six AC power supplies can be installed in an EX8200 switch. All AC power supplies install in
240