Handling And Storing Line Cards; Holding A Line Card - Juniper EX8208 Hardware Manual

Handling and Storing Line Cards

IN THIS SECTION

Holding a Line Card | 262

Storing a Line Card | 266
Components in the line cards are fragile. To avoid damaging the line cards, follow the procedures in this
topic. The procedures use the following terms to describe the four edges of the line cards:
Faceplate—Edge of the line card that has connectors into which you insert the transceivers.
Connector edge—Edge opposite the faceplate.
Top edge—Edge at the top of the line card when the line card is vertical.
Bottom edge—Edge at the bottom of the line card when the line card is vertical.
CAUTION:
irreparable damage to them.
Holding a Line Card
You must hold a line card horizontally when installing it in the chassis. You may hold a line card vertically
or horizontally when carrying it.
CAUTION:
chassis.
To hold a line card vertically:
1. Orient the line card so that the faceplate faces you. To verify the orientation, confirm that the text on
the line card is right-side up.
2. Place one hand around the line card faceplate about a quarter of the way down from the top edge. Do
not press hard on it.
Failure to handle line cards as specified in these procedures can cause
Be prepared to support the full weight as you slide the line card into the
262