Led Test - Alcatel-Lucent 1665 Installation Manual

Installation tests

LED test

............................................................................................................................................................................................................................................................
Description
This test verifies proper operation of all LEDs on the 1665 DMX circuit packs. Operation
of all the LEDs is necessary to assist in trouble isolation.
Important!
pack or shelf and replace the faulty unit.
Important!
the test for all valid circuit pack positions.
LED test procedure
........................................................................................................................................................................................................................
Select Fault -> Test -> LED...
1
........................................................................................................................................................................................................................
2 Choose shelf (1665 DMX).
........................................................................................................................................................................................................................
Click Select.
3
........................................................................................................................................................................................................................
Choose Number of Iterations: 1.
4
........................................................................................................................................................................................................................
Click OK.
5
Result:
seconds, and then the proper LEDs will light to indicate the current status of the shelf.
........................................................................................................................................................................................................................
Check off the appropriate box in
6
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
4 - 5 6
If there are any LED failures, determine if the problem is with the circuit
If the shelf is not fully equipped, move circuit packs around and repeat
All LEDs on the shelf should light for 10 seconds, then extinguish for 10
S
F T E P S
Appendix E, "Installation checklist".
365-372-304R7.1
Issue 1, November 2007
LED test