Sequencing Beats With Step Mode - Native Instruments Maschine Jam Manual

Element
Unit
OTHER
Gate
Lock
Hold
6.2.3

Sequencing Beats with Step Mode

Step Mode turns your controller into a fully featured step sequencer. If you are familiar with
classic drum machines, you should quickly feel at home.
Description
Selects from three variations of the original note length defined by
the RATE parameter: NORMAL
setting), TRIPLET plays triplets of the original note length (faster,
three notes in the duration of two original notes), and
dotted versions of the original note length (slower, two notes in the
duration of three original notes.
Adjusts the ratio between the duration of the notes and the duration
of the silences between them, measured as a percentage of the note
value set by Rate (see above in the RHYTHM section). Available
values range from 1.0%
short. At 50% notes and silences are equal. At
each note last exactly until the next note is triggered. At higher
values notes overlap (provided that the selected Sound is
polyphonic).
Keeps the Note repeat feature enabled even when you leave Note
Repeat Mode. For example, this can be useful to adjust the settings,
switch to another Pattern, adjust Plug-in parameters, etc., while
keeping Note Repeat running.
The Hold function allows you to latch the notes played by the Note
Repeat. When set to On, the Note Repeat will continuously play a
sequence.
To stop Note Repeat, set the
plays the original note length (default
to 200%: At low values the notes are very
100%
Hold parameter to Off.
Recording and Editing Patterns
Playing and Programming Beats
DOTTED plays
(midcourse)
MASCHINE JAM - Manual - 76