Turbine Manifold - CareFusion LTV 1200 Service Manual

Turbine Manifold

Parts required for replacement:

Turbine Manifold Assembly P/N 11490

Cable Tie P/N 10466

O Donut Seal P/N 10603
2

Silicone Gel Lubricant P/N 10123

RTV Silicone Adhesive P/N 10122
Replace if damaged:

Thermo Conductive Pad P/N 10129

Sealing Gasket P/N 10175

Damping Grommets (4) P/N 10266

Grounding Clips (4) P/N 10752

Green O Port Cover (O
2
When replacing the turbine manifold assembly, it is easiest to remove several components
and replace them together. These will be done in the following order:

Remove the back panel and disconnect the battery

Remove the left soft side

Remove the motor board

Remove the flow valve

Remove the turbine manifold and oxygen blender (LTV
and 1100) as a unit

Disconnect the oxygen blender (LTV
turbine manifold

Connect the new oxygen blender (LTV
turbine manifold

Replace the oxygen blender (LTV
manifold as a unit

Replace the flow valve

Replace the motor board

Replace the left soft side

Reconnect the battery and replace the back panel
70
In the European Union, Loctite® 8104 may be substituted as an equivalent compound.
p/n 18603-001, Rev. J
70
Block) P/N 14446
2
®
1200) or O
®
1200 ) or O
®
1200 ) or O
®
LTV 1200, 1150, and 1100 Ventilator Service Manual
Tools required:

Phillips screwdriver with torque
meter

Grounded anti-static wrist strap

Small dykes or cutters

Mild cleanser

Cable tie tool

Flow Valve Insertion Tool (Mylar)
P/N 14206

Torque screwdriver
(120 in-oz/o.84 Nm)
®
1200) or O
2
®
Block (LTV 1150, and 1100) from the
2
®
Block (LTV 1150, and 1100) to the
2
®
Block (LTV 1150, and 1100) and turbine
2
®
Block (LTV 1150,
Page 8-131