CareFusion LTV 1200 Service Manual page 244

3) Slide the solenoid manifold over the threaded mounting stud on the power board,
carefully align the solenoid contact pins with the JP17 connector on the power board and
press the solenoid manifold into place. Make sure that the contact pins are correctly
located in the JP17 receptacle.
4) Thread one 1/4" solenoid manifold mounting nut (P/N 10342) onto the power board
mounting stud protruding through the solenoid manifold and replace the red solenoid
manifold mounting screw, as shown. Torque tighten both to 20 in-oz (0.14 Nm).
5) Position the flexible tube from port "B" of the accumulator so that it is tucked down
between the purge solenoids and the turbine manifold spacer and attach the turbine
manifold spacer to the turbine manifold. Check to make sure the tube does not get
pinched as you tighten down the four (4) 7/16" spacer screws (P/N 10433). Torque the
screws to 20 in-oz (0.14 Nm).
6) Attach the solenoid mount assembly to the spacer using one (1) 4-24 x 3/8" pan head
screw (P/N 17682-001). Torque to 120 in-oz (0.84 Nm). See page 8-45 for wire routing
instructions.
7) Attach the accumulator to the spacer using two (2) 7/16" pan head screws (P/N 10433).
Torque to 60 in-oz (0.42 Nm).
8) Reattach the flexible tube from the tee and elbow subassembly to port #1 of the solenoid
manifold.
9) Carefully position the small diameter flexible tube with tee fitting, under the elbow
connected to port #7 of the solenoid manifold (routing instructions and diagrams
beginning on page 8-33. Inspect all flexible tubes for tears at the connecting ends and
replace worn or damaged tubes if necessary.
10) Install the analog board using two 1/4" green pan head screws (P/N 10435G). Screws
should be torqued to 60 in-oz (0.42 Nm). See instructions on page 8-57.
p/n 18603-001, Rev. J
®
LTV 1200, 1150, and 1100 Ventilator Service Manual Page 8-123