CareFusion LTV 1200 Service Manual page 181

3) Disconnect the 4-wire flow valve
connector from the motor board.
4) Disconnect the Pisco connector
from the oxygen pressure
transducer. To do this, pinch the
collar on the Pisco connector away
from the Analog board as shown
®
(LTV 1200 only).
5) Disconnect the 2-wire flow valve
thermistor cable from the power
board.
6) Remove the two green screws that
attach the analog board to the
power board and remove the
analog board.
Page 8-60
®
LTV 1200, 1150, and 1100 Ventilator Service Manual p/n 18603-001, Rev. J