Ltm/Ltv Mounting Bracket Temporary Removal (Earlier Model Ltm) - CareFusion LTV 1200 Service Manual

LTM/LTV mounting bracket temporary removal (earlier model LTM)

Parts required for replacement:

None
To temporarily remove the LTM/LTV mounting bracket:
1) Lay the disconnected ventilator on a clean dry surface. Use a 7/64" Allen wrench to
remove the three mounting block screws and mounting block, as shown below.

Retain the screws for reuse when the mounting block is reinstalled.
2) Use a small Philips screwdriver and remove the five ventilator back panel mounting
screws and LTM/ LTV
the Mounting bracket is reinstalled.
p/n 18603-001, Rev. J
Tools required:
®
mounting bracket, as shown. Retain the screws for reuse when
®
LTV 1200, 1150, and 1100 Ventilator Service Manual

Phillips screwdriver with torque meter

7/64" Allen wrench
Page 8-23