CareFusion LTV 1200 Service Manual page 233

10) Insert the cylindrical connector-end of a pigtail cable assembly over the power board
and through the keyed-round hole of the upper weldment from the inside of the upper
weldment.
11) Slide the pigtail cable assembly through the hole in the upper weldment until the strain
relief protrudes through the keyed-round hole in the upper weldment.
12) Slide the electrical connector
interface bracket down through
the recess in the molded strain
relief of the pigtail cable
assembly.
Page 8-112
®
LTV 1200, 1150, and 1100 Ventilator Service Manual
13) Insert and thread two 1/4" flat-
head screws (P/N 10430) through
holes in the left sidewall of the upper
weldment and into the threaded
bosses on the electrical connector
interface bracket. Torque-tighten both
screws to 60 in-oz (0.42 Nm).
14) Plug the 4-wire connector of the
pigtail cable assembly onto the JP6
connector on the power board. Fold
the wires of the pigtail cable assembly
back toward the cavity for the internal
battery.
p/n 18603-001, Rev. J