Ltm/Ltv Mounting Assembly Installation And Removal - CareFusion LTV 1200 Service Manual

LTM/LTV mounting assembly installation and removal

Parts Required for Installation:
Components
The current LTM™ to LTV
17916-001, which contains:

LTM™ to LTV

LTM™ to LTV
®

LTV external accessories screw kit (1), p/n 11149

#4-40 X 3/8" pan-head mounting screws (5), p/n
10879

#4-40 X 5/16" pan-head mounting screw (1), p/n
11356 (not needed for the LTV
1100)

Instruction sheet, LTM™ to LTV
(1), p/n 18081-001
In order to accommodate an LTM™ Graphics Monitor, an LTM/ LTV
must be attached to the LTV
To access internal components of the LTV
be removed.
This section is divided into four sub-sections to accommodate the removal, replacement, or
installation of the LTM/ LTV

Temporary Removal (to allow removal of the back panel for access)

Permanent Removal (to permanently remove the bracket)

Reinstallation (to replace bracket after ventilator maintenance)

Installation (if a mounting assembly was not previously installed)
Page 8-16
®
mounting assembly, p/n
®
mounting bracket (1), p/n 17918-001
®
mounting block (1), p/n 17917-001
®
1200, 1150, or
®
®
1200, 1150, or 1100 ventilator.
®
®
mounting bracket under the following conditions:
®
LTV 1200, 1150, and 1100 Ventilator Service Manual
mounting bracket
ventilator for service, the mounting bracket must
Tools required:

Phillips screwdriver
with torque meter

7/64" Allen wrench
®
mounting assembly
p/n 18603-001, Rev. J