Table of Contents
Advertisement
4080, 4080D
%AANNTTCCFF
Response
!AA(cr)
?AA(cr)
terminal was not grounded when changing baud rate or
checksum setting were attempted.
There is no response if the module detects a syntax or
communication error, or even if the specified address does
not exist.
!
?
command.
AA
address of the module.
(cr)
Example
command: %0120510600(cr)
response:
The ADAM 4080D module is configured by changing
address 01 to a new address 20, choosing frequency
measurement module, assigning 9600 to baud rate, setting
frequency gate time 0.1 second and no checksum checking
or generation.
The response indicates that the command was received.
Wait seven seconds to let the new configuration settings
take effect before you issue a new command to the module.
Baud Rate Code (Hex)
NOTICE: You can change all configuration parameters dynamically
except checksum and baud rate parameters. They can only be
altered when the INIT* terminal is grounded.
7-30 ADAM 4000 Series User's Manual
if the command is valid.
if an invalid parameter was entered or the INIT*
is a delimiter character which indicates a valid command.
is a delimiter character which indicates an invalid
(range 00-FF) represents the 2-character hexadecimal
is the terminating character, carriage return (0Dh).
!20(cr)
Table 4-7 Baud Rate Codes
03
04
05
06
07
08
Digital I/O and Relay Output
Counter/Frequency Command Set
Baud Rate
1200 bps
2400 bps
4800 bps
9600 bps
19.2 Kbps
38.4 Kbps
Advertisement
Table of Contents
