Copyright Notice This document is copyrighted, 1998. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of the original manufacturer.
If any of these items are missing or damaged, contact your distributor or sales representative immediately. Technical Support and Sales Assistance If you have a technical question, please visit Advantech's support website, located at: http://support.advantech.com.tw For more information about Advantech's products and sales service, please visit our homepage located at: http://www.advantech.com.tw...
100 Mbps with minimum Interframe Spacing (IFS). The MIC-3660 can be connected to 10 or 100 Mbps Ethernet net- work. It detects the speed of the network and switches to 10 or 100 Mbps operation automatically.
Specifications • IEEE 802.3/802.3u 10Base-T and 100Base-TX compatible • CompactPCI Specification 2.0 R 2.1 compliant • Complies to PCI Bus Specification R 2.1 • IEEE 1101.10 compliant handle and front panel • RJ-45 connector: The RJ-45 connector can use IEEE 802.3 10Base-T compliant Category 3, 4, or 5 cables.
Keep the card in its antistatic packaging when it is not installed in the PC, and place it on a static dissipative mat when you are working with it. Wear a grounding wrist strap for continuous protection. MIC-3660 User's Manual...
It should be free of marks and scratches and in perfect working order on receipt. As you unpack the MIC-3660, check it for signs of shipping damage (damaged box, scratches, dents, etc.). If it is damaged or fails to meet specifications, notify our service department or your local sales representative immediately.
Boot ROM socket (Default Vpp = +12 V, open R25 and short R26 to change to +5 V) CN1: RJ-45 10/100 Mbps LAN connector LINK LED ACT LED 100 Mbps Figure 2-1: MIC-3660 connector locations Chapter 2 Hardware Installation...
There are three diagnostic LEDs on the front panel. These LEDs show the operating status of the MIC-3660. LINK Mbps Figure 2-2: MIC-3660 front panel LEDs Table 2-1: MIC-3660 front panel LED indicators Indicator Meaning LINK The linking between the switch and...
Card Installation The MIC-3660 is a PCI bus master card. It can be installed only in a CompactPCI slot which supports a bus master card. Some processor boards do not support bus master for each slot. Refer to the user's manual of your processor board.
Drivers Installation The MIC-3660 supports PCI Plug and Play. The BIOS automatically detects the MIC-3660 while booting, and assigns an IRQ level and I/O address. No jumper and switch is required for user configuration. The MIC-3660 uses an Intel 82558B Fast Ethernet controller chip. Thus it is software compatible with Intel's EtherExpress™...
When connecting your network, you must ensure the correct wiring and termination methods are employed. The MIC-3660 accepts an RJ-45 connector, as shown below. To connect the twisted pair Ethernet (TPE) cable to the adapter, orient RJ-45 jack with the connector so the key is aligned with the slot. Then gently push the connector into the receptacle until you hear or feel a click.
RJ-45 jack. This cable is responsible for the transmission and reception of all data over the network. Refer to the table and diagram below for the pin assign- ments. Table 3-1: MIC-3660 RJ-45 pin assignments Signal Description Transmit positive...