Table of Contents
Advertisement
Menu Operations
The method of menu operation is basically the same when
using a mouse with an external monitor, but with mouse
clicks in place of button presses. There is no difference in
the menu control block operation described here.
However, the monitor has no knobs for adjusting the
parameters in the menu control block.
For details of operations corresponding to these knob
operations, see the section below, "Operation With a
Mouse" (page 85).
Selecting an Item
1
Press the VF button (1 to 7) for the desired group of
items.
The HF button (1 to 7) indications change to show the
items within the selected group.
2
Press the HF button for the desired item.
The indications in the status area and function button
area change, and you can now make various changes
to the selected item.
Selecting a Function
Press the appropriate function button within the function
button area.
Shape and color of the button
Pressing the button turns it on, and it lights, showing the
state.
Lit pale blue: The function is enabled, and the parameters
can currently be adjusted with the knobs.
Lit orange: The function is enabled.
Lit purple: Execution button. Pressing the button
immediately executes the function (Example: [Auto
Start] in the Chroma Adjust menu).
84
Menu Operations
Pressing a button of this type displays a further menu,
allowing more detailed settings (Example: [Chroma
Adjust] in the Type menu).
Setting Parameters
The mark above on a function button indicates that there
are parameters which can be adjusted with the knobs.
Pressing this function button assigns parameters to the
knobs.
You can set the parameter values by either of the following
methods.
• Turn the knob (1 to 5) corresponding to the parameter, to
adjust the value.
• Press the knob parameter buttons (1 to 5) corresponding
to the parameter. This displays the numeric keypad
window allowing you to enter the desired value.
In the description of specific setting procedures, the knob
adjustment is described, as follows.
Example: When wipe pattern key is selected
Knob
Parameter
Adjustment
1
Size
Pattern size
2
Soft
Edge softness
3
Density
Key density
When the [MENU] button in the device control block is lit,
you can use the trackball and Z-ring to control the
parameters.
• Move the trackball on the X-axis to control the
parameter for knob 1 or on the Y-axis to control the
parameter for knob 2. Moving up or to the right increases
the parameter value, and moving down or to the left
decreases the parameter value.
• Use the Z-ring to adjust the parameter for knob 3.
Turning clockwise increases the parameter value, and
turning counterclockwise decreases the parameter value.
Switching Between the Main Menu
Site and Subsidiary Menu Site
For menu transitions, you can store two separate versions
in the main and subsidiary menu sites.
By switching sites, and pressing the b button and the B
button you can trace the history in each menu.
mark
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
Advertisement
Table of Contents
