Setting The State Of Buttons That Are Not Lit; Setting Beep Sound For Touch Operation; Calibrating The Touch Panel; Setting The Menu To Display At Startup - Sony XVS-9000 User Manual

Setting the State of Buttons that are
Not Lit
In the Engineering Setup >Panel >Maintenance menu
(7327), press [Panel Glow].
To make unlit buttons visible in dark lighting conditions
(dimly lit state), press [Panel Glow], turning it on. To turn
the display of unlit buttons off, press [Panel Glow], turning
it off.
Setting Beep Sound for Touch
Operation
In the Engineering Setup >Panel >Maintenance menu
(7327), press [Touch Beep].
To enable the beep sound, press [Touch Beep], turning it
on. To disable the beep sound, press [Touch Beep], turning
it off.

Calibrating the Touch Panel

1
In the Engineering Setup >Panel >Maintenance menu
(7327), press [Touch Panel Calibration].
The following message appears.
"To Perform Calibration, please touch the center of
each plus sign."
2
Press [Yes].
3
Press the center of the plus sign displayed on the
screen.
The plus sign disappears and then reappears
diagonally.
4
Press the center of the plus sign.
5
Check the message, then press [Yes].
Setting the Menu to Display at
Startup
1
In the Engineering Setup >Panel >Maintenance menu
(7327), press [Initial Menu Set].
2
Enter the page number of the menu to set in the pop-up
window.
Note
To enable this setting, the initial state of the control panel
when powered on must be set to one of the following.
• Set to Resume mode
• Set to Custom mode, with [User] selected in the <Setup>
group.
For details, see "Power-On (Startup) State Selection"
(page 391).
Inhibiting Operation in the Sub Menu
Site
In the Engineering Setup >Panel >Maintenance menu
(7327), press [Sub Menu Op Inhibit], turning it on.
To cancel operation inhibit, press [Sub Menu Op Inhibit],
turning it off.
Note
When operation is inhibited, a menu can still be selected
and displayed in the sub menu site, but function settings
and parameter adjustments cannot be made.
Setting the Mouse Wheel Function
when Setting Parameters
In the <Mouse Wheel Direction> group of the Engineering
Setup >Panel >Maintenance menu (7327), select one of the
following.
Scrl Down = Clockwise: Scrolling the mouse wheel down
is the same as turning a parameter setting knob
clockwise.
Scrl Up = Clockwise: Scrolling the mouse wheel up is the
same as turning a parameter setting knob clockwise.
Setting the Mouse Button Function
when Setting Parameters
In the <Mouse Slider Control> group of the Engineering
Setup >Panel >Maintenance menu (7327), select one of the
following.
Left Button: Dragging while holding down the left mouse
button adjusts the parameter setting button bar.
Right Button: Dragging while holding down the right
mouse button adjusts the parameter setting button bar.
Note
When [Left Button] is selected, the numeric keypad
window is not displayed, even when a parameter setting
button is pressed.
429