Table of Contents
Advertisement
2-5.
EXERC RES
1.
DVS-2000C
CPU-156 Board
S4(C-2)
Sa(C-1)
$11(J-2)
oO
inal
$10(J-2)
(Component Side/A Side)
$4 (C-2): DBGAT vy F
REO
MBA AT
FCT.
MRWEHLE VCC RS
TAB
RE: 3ST OFF
Tea hae: O
DVS-2000C
2-5.
CONFIRMATION IN INSTALLATION
2-5-1.
Switch Setting on Board and LED Description
Note
The address on the board is shown by ( ) mark.
Factory setting
$4 and S6
$4 (C-2): DBG switch
This switch is used for adjustment in the factory.
Not change this setting.
Factory setting: All OFF position
$6 (C-1): ABORT switch
This switch is used for adjustment in the factory.
Not change this setting.
$10 (J-2): D/A clock select switch
This switch is used for selecting the clock rate.
The clock rate is used when the digital signal input to the D/A
input connector is converted into the analog signal. This
switch is used for adjusting the circuit.
,
For the details of the setting, refer to Section 1-6 of
Maintenance Manual Parti.
Factory setting: 0
$11 (J-2): D/A clock phase control switch
This switch is used for fine adjusting the clock phase.
The clock used in converting the digital signal input to D/A
input connector into the analog signal is selected by switch
S10. This switch is used for adjusting the circuit.
For the details of the setting, refer to Section 16 of
Maintenance Manual Part1.
Factory setting: 1
TEA
Advertisement
Table of Contents
