Adjusting the Reference Phase
To adjust the switcher internal reference phase, in the Switcher >Config menu,
set the following parameter.
Knob
3
Specifying the Video Switching Timing
1
2
Note
When the signal format is set to 720P, this selection is not possible.
Setting the Operation Mode
In the <M/E Config> group of the Switcher >Config menu, select the operation
mode for each M/E or PGM/PST bank from the following.
• Standard mode
• Multi Program mode
For details of the modes, see the explanation of the M/E Config function (page
125).
Note
When Multi Program mode is selected, two or more transition type indication
may light. It is also possible that more than one "Transition Type" has been
selected in the Misc >Transition menu for each M/E.
Assigning the output of each bank in Multi Program mode
When you selected [Multi Program] as the operation mode, use the following
procedure.
126
Settings for Switcher Configuration (Config Menu)
Parameter
Adjustment
Phase
Switcher internal reference phase
In the Switcher >Config menu, press [Switching Timing].
The Switching Timing menu appears.
Select any of the following.
Any: Not specified
Field 1: Field 1 (odd fields)
Field 2: Field 2 (even fields)
Setting values
–32.00 to +96.00