Setting The Operation Mode Of The [All] Button In The Transition Control Block; Setting Device Control Block Button And Trackball Operation; Setting The Macro Execution Mode - Sony XVS-9000 User Manual

Note
Enable using the [AUTO TRANS] button in the
independent key transition execution section on the
transition control block, independent key transition control
block, or key fader control block.
Setting the [TRANS PVW] button operation mode
In the <Trans Pvw> group, select one of the following.
Hold: Enables transition preview mode only while the
[TRANS PVW] button is pressed.
Lock: Pressing the [TRANS PVW] button switches
between transition preview mode and normal mode
each time the button is pressed.
The one-time mode setting is set in the Engineering Setup
>Switcher >Transition menu (7334) (see page 456).
Setting the [KEY] button operation mode when a
key source bus is selected
In the <Key Source Bus Select Mode> group, select one of
the following.
Key: The [KEY] button is always lit, and only key signals
are selected using the cross-point buttons.
Video & Key: Enables key signals or video signals to be
selected using cross-point buttons, according to the
[KEY] button operation.
For details about the [KEY] button operation, see "To
select a video signal assigned to a cross-point button"
(page 111).
Setting the [UTIL] button operation mode
In the <Util Button> group, select one of the following.
Hold: Enables utility bus mode only while the [UTIL]
button is pressed.
Lock: Pressing the [UTIL] button switches between utility
bus mode and normal mode each time the button is
pressed.
Exchanging the [AUTO TRANS] button and [CUT]
button in the transition control block
Press [Auto Trans/Cut Swap], turning it on.
Setting the Operation Mode of the
[ALL] Button in the Transition
Control Block
This sets the next transition selected by the [ALL] button
in the transition control block.
1
In the Engineering Setup >Panel >Operation >Custom
Button/Fader menu (7326.4), press [Next Trans All].
The Next Trans All menu (7326.11) appears.
2
In the <Next Trans All> group, select the button for the
next transition.
Note
If all next transition buttons are disabled, the next
transition cannot be set even if the [ALL] button is
pressed.
Setting Device Control Block Button
and Trackball Operation
In the Engineering Setup >Panel >Operation menu (7326),
press [Sensitivity] to open the Sensitivity menu (7326.5).
Configure each function, as required.
Setting the trackball and Z-ring sensitivity in
normal mode
In the <Trackball Normal Mode> group, select one of the
following.
×1: Standard (default travel speed)
×2: Move at 2× speed.
×4: Move at 4× speed.
Note
This setting is disabled in the following operation modes.
• Keyframe operation mode
• VTR/disk recorder/frame memory operation mode
Setting the trackball and Z-ring sensitivity in fine
mode
In the <Trackball Fine Mode> group, select one of the
following.
1/2: Move at 1/2 speed
1/4: Move at 1/4 speed
1/8: Move at 1/8 speed
Note
This setting is disabled in the following operation modes.
• Keyframe operation mode
• VTR/disk recorder/frame memory operation mode
Setting the sensitivity when recalling a menu
using button double-press
In the <Double Click> group, select one of the following.
Fast: High speed
Normal: Normal
Slow: Low speed

Setting the Macro Execution Mode

1
In the Engineering Setup >Panel >Operation menu
(7326), press [Macro].
The Macro menu (7326.6) appears.
423