Setting The Output Signal - Sony MVS-8000X User Manual

2
In the <Output Assign> group, select either of the
following.
[Re-Entry Source]: It is possible to make duplicate
assignments.
M/E-1 Output 1 to 6
M/E-2 Output 1 to 6
M/E-3 Output 1 to 6
M/E-4 Output 1 to 6
a)
PGM/PST 1 to 6
M/E-1 to 4 Proc Video
P/P Proc Video
M/E-1 to 4 Proc Key
P/P Proc Key
DME Monitor Video
DME Monitor Key
Color Corrector 1 and 2
Undefined
Color Bkgd 2
[Aux Bus]: It is not possible to make duplicate
assignments.
Preset
Edit Preview
AUX 1 to 48
a) M/E output signals selected in the M/E Output Assign menu.
3
Using any of the following methods, select the output
port number and signal to be assigned.
• Press directly on the list in the status area to make the
selection.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
Knob Parameter Adjustment
1 Output No Output port
number
2 Source No Selection of
signal to be
assigned
• For output ports not to be assigned, press [Inhibit].
The selected signal appears in reverse video.
4
Press [Set] to confirm the assignment.

Setting the Output Signal

In the following adjustment/setting operations, use any of
the following methods to select the output signal before
making the setting.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a)
a)
a)
a)
Setting values
1 to 48
1 and upwards
Knob Parameter Adjustment
1 Output No Output port number
selection
The selected output signal appears in reverse video.
Adjusting the video clip
To adjust the clip value for each of the output signals from
the Output 1 to 48 ports, use the following procedure.
1
In the Switcher >Output menu, press [Video Clip].
The Video Clip menu appears.
The status area shows the output ports and assigned
signals, and the white clip, dark clip, and chrominance
clip values.
2
Adjust the following parameters.
Knob Parameter Adjustment
2 White Clip Luminance
signal white clip
value
3 Dark Clip Luminance
signal dark clip
value
4 Chroma Chrominance
Clip signal clip value
To set the values to the default values, press [Default].
Making vertical blanking interval
adjustment and through mode settings
1
In the Switcher >Output menu, press [V Blank/
Through].
The V Blank/Through menu appears.
The status area shows the output ports and the assigned
signals, the vertical blanking interval, and the through
mode Enable/Disable status.
2
Press [V Blank Mask].
3
Adjust the parameter.
Knob Parameter Adjustment
2 Mask End Final value for
vertical blanking
interval
a) Depending on the signal format, the adjustment range varies as
follows.
480i: 10 to 19
576i: 6 to 22
1080i/1080PsF: 7 to 20
720P: 7 to 25
1080P: 15 to 41
To return the values to their defaults, press [Default].
Signal Output Settings (Output Menu)
Setting values
1 to 48
Setting values
90.00 to 109.02
–6.85 to +10.00
90.00 to 113.17
Setting values
See note a)
below
533