Setting The Output Signal; Assigning An Output Signal - Sony MLS-X1 User Manual

5
Set the look conversion function using the [Look
Conversion] button.
On: Enable look and black compression.
Press the [Input Look] button and select an input
look (Live, Mild, Natural) from the pull-down
list.
Enable/disable the input black compression
function using the [Input Black Comp.] button.
Press the [Output Look] button and select an
output look (Live, Mild, Natural) from the pull-
down list.
Enable/disable the output black compression
function using the [Output Black Comp.] button.
Off: Disable look and black compression.
Note
This cannot be set when the input signal conversion
mode is set to [Air Matching Off] or [Display
Referred].
Returning [HDR Converter] window
settings to the initial settings
Press the [Default Recall] button in the [HDR Converter]
window.
The settings on all tabs in the [HDR Converter] window
are returned to the following values.
[Config] tab: System settings values
[Conversion] tab: System settings values
[Additional Paint] tab: Default values

Setting the Output Signal

This section describes how to set the switcher output
signal.
In a multiple-box switcher configuration, there are two
types of switcher output signals.
Dedicated output:
Outputs the internal signal of the target box.
The various settings are configured on the [Dedicated
Out] tab in the Home > Setup > System > Output
menus.
Output:
Outputs an Aux, Edit Preview, or Preset signal.
These can also output the internal signal of another
box.
To output the internal signal of another box, the
internal signal of the target box must be sent to the
cross-point box.
For details about sending to the cross-point box, see
"Setting Re-Entry Signals" (page 398).
The various settings are configured on the [Output]
tab in the Home > Setup > System > Output menus.
In a 1M/E box switcher configuration, only the following
signals are output.
Output: Outputs a box internal signal, Aux, Edit Preview,
or Preset signal.
The various settings are configured on the [Output]
tab in the Home > Setup > System > Output menus.
The number of switcher outputs, number of configurable
format converters, and number of configurable color
correctors/HDR converters will vary depending on the
signal format and the number of boxes.
For details about the number of outputs and the number
that can be configured, see "Number of Switcher
Resources" (page 501).
For details about output numbers, see "Input/Output
Numbers" (page 503).

Assigning an Output Signal

You can assign an output signal.
1
Open the Home > Setup > System > Output > Output
Assign menu (19101.41).
2
Select a tab to switch the target to set.
[Output] tab: Assigns output signals to outputs.
[Dedicated Out] tab: Assigns output signals to
dedicated outputs.
373