Table of Contents
Advertisement
3
To set the selected control panel as the tally control
master panel, press [Tally Master], turning it on.
If there are multiple control panels and switchers, the
control panel on which [Tally Master] is enabled
performs tally control for the whole system.
Notes
• When there are multiple control panels, make sure
that one of them has [Tally Master] enabled.
• If the master panel is changed, be sure to copy and
save the setup tally (TLY) and router (RTR) data in
the File menu, and make the same settings on
another panel.
• If the master panel tally data is loaded into a panel
with a different unit ID, then [Tally Master] is
disabled.
• [Tally Master] cannot be enabled on the 4th control
panel (PNL4).
To clear the switcher and master panel settings
Press [Clear].
4
Press [Execute].
5
Check the message, then press [Yes].
Specifying the DME Used on the
Switcher
1
In the Engineering Setup >System >System Config
menu (7312), specify the DME to use.
When selecting a DME on SWR1: Select [DME1] in
the <SWR1> group.
When selecting a DME on SWR2: Select [DME3] in
the <SWR2> group.
2
Press [Execute].
3
Check the message, then press [Yes].
Settings Relating to
Signal Formats
About 4K format
In 4K format, a single 4K image is split into four HD
images, and data is transferred as four signals.
Image processing on the switcher is also performed on four
images using the 2-sample interleave division method.
In 4K format, up to four keys (two keys + two sub keys)
per switcher bank can be used with up to 40 inputs, up to
12 outputs, and up to four format converter outputs.
For details about restrictions of functions and settings for
the 4K format, see "4K Format Restrictions" (page 461).
Setting the Signal Format
The combinations of signal formats that can be selected are
as follows.
Format
Field frequency
4K
59.94
50
HD
59.94
50
29.97
25
24
23.98
59.94
50
59.94
50
Notes
• When using 4K signal formats, software options are
required (see page 369).
• SWR1 and DME1 (and SWR2 and DME3) signal format
settings are linked.
• If two switchers are connected, set SWR1 and SWR2 to
the same field frequency signal format.
1
In the Engineering Setup >System >Format menu
(7313), select the target device to set.
2
Press [Signal Format].
364
Number of
effective scan
lines
(pixels)
2160P
(3840×2160)
1080P
1080PsF
1080i
720P
Advertisement
Table of Contents
