Differences Between Multi Program 2 Mode And Standard Mode; Restrictions On Using Multi Program 2 Mode - Sony MVS-8000X User Manual

Differences between Multi Program 2 Mode and Standard Mode

The differences from operation in standard mode are as
follows.
Item
a)
Keys
Wipes
(background)
Wipes (key)
DME wipes
Transitions
Snapshots
Control from an editor
Operation setting for switcher GPI inputs and
outputs
a) Keys 2 to 8 are common to main and sub.
Notes
• Allow a transition to complete before carrying out main
and sub delegation switching.
• The sub background A bus (utility 2 bus) is shared with
wipe edge border fill. Making a change to one affects the
other.
• Even if the wipe border width is set to the same numeric
value for main and sub, the same image is not obtained.
Restrictions on Using Multi Program
2 Mode
• The following functions are not available for sub:
210
Multi Program 2
Main
Keys 1 to 8 can be used
Patterns Same as standard mode
Modifiers Same as standard mode
Same as wipes (background) for sub
Use Can be used
Patterns for 1 channel For a dedicated interface, each of main and sub can be used.
For the SDI interface, only one of main and sub can be used.
Patterns for 2 channels Only one of main and sub can be used
(For each M/E, the number of DMEs that can be used is the same as in
Patterns for 3 channels
standard mode.)
Backgrounds Wipe edge fill matte (including color
mix and other settings in the Matte
Adjust menu)
Modifiers Same as standard mode
Key priority Cannot be used
Transition preview Cannot be used
Preset color mix Color matte or video signal selected
on the utility 2 bus
Cross-point hold Utility 2 cannot be set
Same as standard mode
Same as standard mode
Sub
Keys 2 to 8 only can be used
• Only standard patterns can be used
• Pattern mix is not possible
• Pairing, modulation, spring, spiral,
and split cannot be used
• Edge fill mattes are single-color
only
• Replication can be selected from
four patterns
Cannot be used (Can be used, with a
setting change)
Wipe edge fill matte (single-color
only)
Wipe border colors are single-color
only
Color matte only
Utility 3 is added. BKGD A/B and
Key1 cannot be set.
Cannot be used
Cannot be used
- Data copy and swap
- Default recall (except for parametric recall)
• Re-entry is limited to five levels. Re-entry is not possible
for main and sub of the same M/E.
However, this restriction can be removed.
For details, see "Enabling re-entry between the main
and sub sides of the same M/E bank" (page 209).
• In the following cases, a transition using the fader lever
may not be performed correctly:
- When the main and sub bus toggle modes are set
differently
- For a pattern mix, preset color mix, and so on
• For an Internal bus link, GPI link, or External bus link,
the "Utility 2" bus cannot be selected.
• Screen aspect, show key, and [MCRO ATTCH ENBL]
button settings are common to main and sub.
• If a snapshot is recalled simultaneously for main and
sub, or a keyframe is executed simultaneously for main