Functions Added In Multi Program 2; Mode; Differences Between Multi Program 2 Mode And Standard Mode - Sony XVS-9000 User Manual

On the XVS-6000, up to eight re-entry stages are
supported, with the final output having a delay of 4H.
• The selection order of re-entry signals affects the
number of lines by which the output signal is lowered.
• If a delay occurs in the image, even when through mode
is set, the ancillary data does not pass through.
• For example, it is possible to select re-entry of M/E-1
main on M/E-1 main.
Restrictions on re-entry when using Multi
Program 2
Snapshots are affected by the re-entry function.
When [MP2 Free Re-Entry] is enabled, the following
restrictions apply when a switcher bank is in Multi
Program 2 mode.
If you save and recall snapshots simultaneously with more
than one region specified, the recorded state is reproduced
in the order of precedence of regions (M/E-1 >M/E-2 >M/
E-3 >M/E-4 >M/E-5 >PGM/PST). Therefore, if you save
and recall a snapshot with more than one region specified,
the cross-point settings may not be recalled correctly.
To recall a snapshot correctly, press the cross-point button
before recalling the snapshot, to select a signal other than
the re-entry signal, then recall the snapshot.

Functions Added in Multi Program 2

Mode

• You can set the video process for the utility 3 bus signal.

Differences Between Multi Program 2 Mode and Standard Mode

The differences from operation in standard mode are as
follows.
Item
a)
Keys
Wipes Patterns
(background)
Modifiers
Wipes Patterns
(keys)
Modifiers
• "Sub Cut" and "Sub Auto Trans" on each switcher bank
are added to the selectable actions in the SIU (DCU
function) GPI input settings.
• "Main&Sub" and "Sub" are added to the macro event
configuration parameters and macro attachment settings.
• "Sub Program," "Sub Preset," and "Sub Trans PGM" on
each switcher bank are added to the link source bus for
cross-point button link settings.
• Snapshot attributes can be set independently for main
and sub.
• Menus for the sub bank are added to menus that can be
recalled by pressing a button twice.
• [MP2 Auto Correct] settings are available in the Effect
menu or Snapshot menu. For example, enabling this
determines whether the copy destination and copy
source data is the main bank or sub bank, and
automatically switches the data.
• The [SUB TRANS] button on the key control block is
enabled. This functions as the [TRANS] button for the
sub bank.
• You can display whether key 1 to key 8 are assigned to
the main bank or the sub bank in the display of the
transition control block.
• On the cross-point pad of the cross-point control block,
cross-point hold of the utility 3 bus can be set.
Also, main and sub information is displayed on the
switcher bank display buttons.
• The [MAIN] button and [SUB] button are enabled on the
transition control block and transition control block
(simple type).
Main
Key 1 to key 8 can be used
Same as standard mode
Same as standard mode
• Only standard wipe patterns can be used
• Pattern mix cannot be used
• Split, pairing, modulation, spring, and spiral cannot be used
• Edge fill mattes are single color only
• Four types of multi replication are available for selection.
203
Sub
Key 2 to key 8 only can be used
• Only standard wipe patterns can be
used
• Pattern mix cannot be used
• Split, pairing, modulation, spring, and
spiral cannot be used
• Edge fill mattes are single color only
• Four types of multi replication are
available for selection.