APRILIA SHIVER 900 Service Station Manual page 80

Electrical system
5. Air temperature sensor for instrument panel indication
6. Headlamp
7. Starter relay
8. Coils
9. Spark plugs
10.Starter motor
11.Taillight
12.Secondary fuses
13.Main fuses
14.Handle position sensor
15.Gearbox in neutral sensor
16.Rpm sensor - pick up
17.Engine temperature sensor
18.Throttle valve management control unit
19.Lambda probe
20.Fall sensor
21.Main injection relay
22.Engine control unit
23.Front speed sensor
24.Rear speed sensor
25.Electronic control unit
THE IDENTIFICATION OF THE RELAY CANNOT BE CARRIED OUT JUST ON THE BASIS OF THE
INDICATIONS BELOW: IN ANY EVENT IT SHOULD OCCUR WITH THE IDENTIFICATION OF THE
COLOUR OF THE RELAY CABLES.
Location of the
component in the
electrical circuit
diagram
7
8
17
31
35
38
Electrical system installation
INTRODUCTION
Scope and applicability
The position of the wiring harnesses, how they are fixed to the motorcycle and potential problems are
defined on the following sections in order to reach the objectives of vehicle reliability.
ELE SYS - 80
R
ELAY LAYOUT
Component name
High beam lights relay
Light relay
Main injection relay
Start-up relay
Secondary injection relay
Fan control relay
SHIVER 900
Position on the vehicle:
Right front side of the filter housing
Right front side of the filter housing
Left front side of the filter housing
Left front side of the filter housing
Right front side of the filter housing
Left front side of the filter housing