APRILIA SHIVER 900 Service Station Manual page 81

SHIVER 900
Motorcycle division
The wiring timing is subdivided in three essential
sections, as indicated in the figure.
1. Front section
2. Central section
3. Rear section
SPECIAL CHECKS FOR THE CORRECT CONNECTION AND LAYING OF CABLES
Once the electrical system has been replaced, the connectors have been reconnected and the
various clamps and fasteners have been repositioned, carry out the checks described below.
•
Check that the following connectors have been connected correctly and that appropriate
tightening torque has been applied when securing them to the connector block.
1. Instrument panel connector: FRONT SECTION - TABLE B4.
2. Ride By Wire Connector: CENTRAL SECTION - TABLE A4.
3. Timing sensor connector: CENTRAL SECTION - TABLE M2.
4. Side stand switch connector: CENTRAL SECTION - TABLE O2
5. Voltage regulator connector: CENTRAL SECTION - TABLE M2-M3.
6. Front cylinder coil and rear cylinder coil connectors: ENGINE, TABLE A12.
7. Main wiring harness connector: CENTRAL SECTION - TABLE A1.
8. Control unit connector: ENGINE, TABLE A14.
9. Earth: CENTRAL SECTION, TABLE B
10.Fuel pump connector: CENTRAL SECTION, TABLE B.
11.Key Connector - RH Column light switch connectors - LH Column light switch connectors: Con-
nectors housed inside the hood behind the radiator: FRONT SECTION - TABLE A3
12.ABS control unit connector.
13.Front and rear speed sensor connectors: FRONT SECTION, TABLE C3 and REAR SECTION,
TABLE A3
14.Secondary fuses (correct position)
•
THE LISTED CONNECTORS ARE CONSIDERED TO BE THE MOST CRITICAL IN COM-
PARISON WITH ANY OTHER BECAUSE THE VEHICLE WILL STOP IF THEY ARE
ACCIDENTALLY DISCONNECTED.
•
Undoubtedly the connection of the rest of connectors is also important and essential for the
correct operation of the vehicle.
Electrical system
ELE SYS - 81